Hybrid Car – More Fun with Less Gas

Is any of this even cost effective yet? - Page 8

register ::  Login Password  :: Lost Password?
Posted by Jim Rojas on December 19, 2010, 3:46 am
 
Curbie wrote:

I am reposting this again for those of you who missed it...


RPM is a combination of technologies that have been around for a very
long time. This is all hands on stuff...no plug & play here.

a PWM (pulse width modulator) allows a DC motor, or a set of trigger
coils to spin at much higher frequency speeds than of 60Hz limitation
now has. A VFD (Variable Frequency Drive) can be used on 220-480 AC
motors to accomplish the same thing. So a DC motor rated at 24VDC
1800RPM 60Hz can spin at speeds upwards to 10,000RPM and 300+Hz. This
gives the motor more low end torque, while consuming the same or less
energy. The key here is torque.

So imagine the PWM motor directly attached to a 50-100 pound flywheel,
spinning at let's say 1000 RPM. You can then use a series of
magnetically driven pulleys to spin a series of AC and/or DC motors at
same RPM or higher by making different pulley sizes. The result is much
less drag, and the ability to compensate for load drag using a auto
servo circuit to keep RPM constant under heavier loads.

Watch this video to see the magdrive in action:




This video will explain in full detail how to build one:

http://www.youtube.com/profile?annotation_id=annotation_932309&user=MindFreer&feature=iv#p/u/0/TMxkkz2VTGA


This video shows you how to build a grid tie inverter with off the shelf
parts:

http://www.youtube.com/profile?user=PTranCypress#p/u/0/12E6bQ1OksU


Here is a video on what a Bedini circuit is:



I took several different ideas, and made it work for my RPM setup. What
I did on my setup was to use the Bedini approach to run & charge 2 banks
of batteries that only run my PWM.

My PWM is run with the Bedini style circuit. Battery Bank A (24v 18AH)
runs my PWM. The Bedini then charges Battery Bank B (24v 18AH). I then
use a DPDT relay, and an mechanical appliance timer to swap batteries.
Bank A drives the PWM, Bank B charges, then after an hour Bank B then
drives the PWM, and Bank A charges.

Jim Rojas


Posted by Jane_Galt on December 19, 2010, 4:21 am
 


Well what drives the whole thing, to PRODUCE ENERGY?

--
- Jane Galt

"Remember that there is no such dichotomy as 'human rights' versus
'property rights.' No human rights can exist without property rights. Since
material goods are produced by the mind and effort of individual men, and
are needed to sustain their lives, if the producer does not own the result
of his effort, he does not own his life. To deny property rights means to
turn men into property owned by the state. Whoever claims the 'right' to
'redistribute' the wealth produced by others is claiming the 'right' to
treat human beings as chattel." -- Ayn Rand


Posted by Curbie on December 19, 2010, 4:44 am
 
Dreams.

Sorry, he chose your honest question to advocate this non-sense.

Curbie

Posted by m II on December 19, 2010, 4:51 am
 On 10-12-18 09:44 PM, Curbie wrote:

It's one of these free energy motors. One of them is claimed to be
120,000 percent efficient. The inventors of these things are all secret
Trillionaires.

http://www.free-energy-info.co.uk/Chapter1.pdf




mike

Posted by Jane_Galt on December 19, 2010, 5:52 am
 

Oh well, usenet, I'm a big girl...

That's what K-0 is for. :)

--
- Jane Galt

"Remember that there is no such dichotomy as 'human rights' versus 'property
rights.' No human rights can exist without property rights. Since material
goods are produced by the mind and effort of individual men, and are needed
to sustain their lives, if the producer does not own the result of his
effort, he does not own his life. To deny property rights means to turn men
into property owned by the state. Whoever claims the 'right' to
'redistribute' the wealth produced by others is claiming the 'right' to treat
human beings as chattel." -- Ayn Rand


This Thread
Bookmark this thread:
 
 
 
 
 
 
  •  
  • Subject
  • Author
  • Date
please rate this thread