Hybrid Car – More Fun with Less Gas

California schools $20M solar project - Page 13

register ::  Login Password  :: Lost Password?
Posted by krw@att.bizzzzzzzzzzzz on June 4, 2010, 3:41 am
 
On Thu, 03 Jun 2010 22:08:33 -0400, "Michael A. Terrell"


and a

yet

sometimes

My RAS is a Craftsman.  The table saw is a Delta Unisaw, I bought last year. I
was going to buy one a few years ago but knew we were going to try to get out
of Vermont.  I didn't see the point in moving a 600lb saw into our basement
and then hauling it back out in a year or two.  So I waited until we moved and
bought another house.  It's living in the garage now so I could wheel it into
the driveway.  The door open is good enough.  It'll move upstairs when I get
the room finished (probably another year).

Posted by Michael A. Terrell on June 4, 2010, 5:36 pm
 

"krw@att.bizzzzzzzzzzzz" wrote:

   The garage is good enough for me.  I'd have to build an elevator if I
had a second floor. :(


--
Anyone wanting to run for any political office in the US should have to
have a DD214, and a honorable discharge.

Posted by krw@att.bizzzzzzzzzzzz on June 5, 2010, 12:30 am
 On Fri, 04 Jun 2010 13:36:13 -0400, "Michael A. Terrell"


Understood.  There is access to the second floor of the house.  I'll be
putting a (bought it from HF last year) hoist in any time, to get the sheet
goods up, then the tools.  

Posted by Michael A. Terrell on June 5, 2010, 6:27 am
 
"krw@att.bizzzzzzzzzzzz" wrote:

year. I

out

and

into

   Better anyone else than me.  I fell three times this week, just
walking through the house.  Luckily, I was next to a wall all three
times and fell against it..


--
Anyone wanting to run for any political office in the US should have to
have a DD214, and a honorable discharge.

Posted by krw@att.bizzzzzzzzzzzz on June 4, 2010, 12:07 am
 On Thu, 3 Jun 2010 13:30:51 -0700, "Joel Koltner"


They have two models.  One is a combination brad nailer and stapler.  This is
just the 1/2" crown stapler.  I have a PC 1/4" crown stapler but it was
pulling through the Kraft paper on some insulation.  I tried an Arrow cordless
electric stapler - useless.  We'll see about this one.


I have a 2HP Penn State dust collector for my table saw and planer but it's in
the garage.  I'm working on my (eventual) shop in the attic, so needed
something to catch the crap coming out of the (Harbor Freight ;) SCMS.  The
shop vac wasn't cutting it.  For $0, I thought I'd give the little portable
HF collector a try.  If it works I'll mount it to a cart with the Dust Deputy
and use it for little jobs.

This Thread
Bookmark this thread:
 
 
 
 
 
 
  •  
  • Subject
  • Author
  • Date
please rate this thread