Hybrid Car – More Fun with Less Gas

flat plate collector

register ::  Login Password  :: Lost Password?
Posted by D Smith on August 4, 2007, 12:46 pm
 
thank you ror your advice

Posted by Anthony Matonak on August 4, 2007, 2:44 pm
 
D Smith wrote:

It occurs to me that what you are going to be making looks
a lot like those hydronic radiant heating things they put
in floors. These consist of Pex sandwiched between aluminum
plates or aluminum with a U shaped channel pressed in the
middle that holds the Pex.

You might look at how these are constructed for ideas.

Anthony

Posted by D Smith on August 5, 2007, 11:23 am
 On Sat, 04 Aug 2007 07:44:50 -0700, Anthony Matonak


Dear Sam above, When I say homebrew I mean DIY or make it yourself
nothing to do with wine or beer.

I already purchased the ally sheets 2 off just over 8*4 I also have a
sheet of marine plywood 8*4 I plan to make a shallow box about 4
inches deep with the plywoon on the bottom. In this box I will put
some insulation about an inch then the ally sheets.

I plan to put spacers in between the sheets about .5 inches thick and
then drill holes about 6mm dia through the spacers and sheets so I can
clamp the rubber pipe in between.

I am off now to pick some blackberries

Posted by sam c on August 8, 2007, 9:15 am
 D Smith wrote:

sorry (re above thread) I misread your post , sounds an interesting
project .
sam c.

This Thread
Bookmark this thread:
 
 
 
 
 
 
  •  
  • Subject
  • Author
  • Date
please rate this thread